Do not spin the bearing with compressed air because this will damage the bearing surfaces. 15 глава
Ч Fasten the radiator fan motor lead and sidestand switch lead to the frame with a plastic holder. Ш Fasten the wire harness and positive battery leads with a plastic band. Face the end of the plastic band upward.
Щ To the starter relay
Ъ Pass the wire harness, rectifier/regulator lead, and rear wheel sensor lead through the guide, making sure that the rectifier/regulator lead is routed below the wire harness and rear wheel sensor lead. Ы Make sure that the seat lock cable do not lean over the storage box.
Ь Fasten the starter motor lead, negative battery lead and seat lock cable (left) to the frame with a plastic holder.
Э Fasten the starter motor lead and negative bat-tery lead to the frame with a plastic holder.
Ю Insert the seat lock cable and the cylinder mounting rubber into the frame stay. Я Pass the O2 sensor lead to the lead guide.
А Fasten the O2 sensor lead to the frame with a plastic band.
Б Fasten the starter motor lead and negative bat-tery lead to the frame with a plastic band. Posi-tion the band clasp on the bottom of the frame and face the band end to the outside.
A A Make sure that the V-belt replacement indica-tor reset coupler does not project out of the clamshell cover. A B Fasten the O2 sensor lead and V-belt replace-ment indicator reset coupler lead to the frame with a plastic holder. A C Pass the wire harness and seat lock cable in the frame holder. A D Pass the rear brake lock lever cable under the coolant pipe.
A F Fasten the wire harness to the frame with the plastic band. The buckle of the plastic band should be facing towards the storage box.
Воспользуйтесь поиском по сайту: ![]() ©2015 - 2025 megalektsii.ru Все авторские права принадлежат авторам лекционных материалов. Обратная связь с нами...
|