Do not spin the bearing with compressed air because this will damage the bearing surfaces. 16 глава
CABLE ROUTING SPEC
A G Fasten the rear wheel sensor lead to the swin-garm with the plastics holders. The open end of each holder should be facing downward.
A H Route the rear wheel sensor lead behind the relay leads. A I 10 ~ 20 mm (0.39 ~ 0.79 in)
A J Fasten the rear wheel sensor lead and wire harness to the frame with the plastic band.
A K Pass the wire harness and rear wheel sensor lead to the frame wire harness holder. A L After making the connections, push the cou-plers into the space inside the frame above the mudguard.
A M Insert the tail/brake light coupler between the wire harness and the seat lock cable (left). A N 20 ~ 30 mm (0.79 ~ 1.18 in) A O To the tail/brake light
A P Route the tail/brake light switch lead under the seat lock cable, wire harness, and positive bat-tery leads and then towards the inside of the vehicle.
CABLE ROUTING SPEC
A Q T stud for position setting
A R Route the seat lock cable through the frame bracket side and under the wire harness.
A S Install the band’s fastened part between frame and storage box.
Воспользуйтесь поиском по сайту: ©2015 - 2024 megalektsii.ru Все авторские права принадлежат авторам лекционных материалов. Обратная связь с нами...
|